Filter/Motor Indicator LED
| Option | Code | LED Color | Action | Notes |
| Filter LED | FL | geen | Noe | Indicates normal operation until filter pressure drop exceeds |
| Yellow | Change Filter | indicates filter pressure drop has exceeded calibrated setting (factoryset at 1.5x clean filter pressure) | ||
| Motor LED | ML | Green | None | Indicates normal motor operation when the static pressure is above 0.2" w.g |
| Red | Troubleshoot motor | Indicates motor is not in operation, and that unit static pressure is below 0.2"w.g. |
Installation
STEP 1: Remove filter from box by following the instructions found on page 23 of this installation manual.
STEP2: Take LED cable assembly out of FFU-HE Plenum
STEP3: Remove well nut in genter port of BTR filter.
STEP 7: With two(2)people holding the unit, pull cable back through plenum until plenum can rest on top of filter.
STEP 8: Refer to BTR Filter instruction found on page 13 for proper filter installation.
STEP 9: Refer to wiring diagram(Located in control box) to connect to the BFC controller instead of the terminal block.
Calibration
All pressure transducers are factoty calibrated. If a different pressure transducer set point is desired.
MOTOR/FILTER INDICATOR
Operation
| Option | Code | Action | Note |
| Motor | MBAS | Troubleshoot Motor | Closes a dry contact to let the signal pass through when the static pressure is less than 0.2w.g. indicating the motor is not operating |
| Filter | FBAS | Change Filter | Closes a dry contact to let the BAS signal pass through when the static pressure is greater than the calibrated pressure drop(factory set at 1.5x clean filter). |
Unit will come factory calibrated; no additional field modifications are required.
Wire unit terminal block according to wiring diagrams
NOTE: Wiring should be carried out by a certified electrician and meet national and local electrical codes.
Pressure switch(es)completes signal when
failure is reached (as per chart above)
FIGURE 18: PRESSURE SWITCH DIAGRAM